Product datasheet - DTT-3

Digital multimeter with relay output, panel mount

Item number:DTT-3 (EAN: 5997374148405)

Technical data 96×96mm

More than 1 pc(s) in stock

Net
346.05263 EUR

Gross 439.48684 EUR

Comparison

Print datasheet

Catalogue pages Declaration Instructions of Use

Protection degree (installed, from the front side)

Protection of terminals (with protection cap)

Indication:

Digital

Multiple display:

Yes

With display backlight:

Yes

Measuring range selection:

Manual

Max. voltage measuring range, AC:

500 V

Lowest resolution, AC voltage:

10 mV

Lowest resolution, DC voltage:

0.0001 mV

Max. current measuring range, AC:

9,500 A

Lowest resolution, AC current:

1000 ?A

Lowest resolution, DC current:

0.0001 ?A

Lowest resolution, resistance:

0.0001 Ohm

Temperature measurement:

Lowest resolution temperature:

0.001 ?C

Capacitance measurement:

Lowest resolution, capacitance:

0.00001 ?F

Frequency measurement:

Max. frequency measuring range:

0.1 kHz

Lowest resolution, frequency:

0.1 Hz

Continuity test:

Max. value storage:

Yes

Min. value storage:

Yes

True RMS measurement:

Yes

Bluetooth interface:

Measuring circuit category:

CAT III

Degree of protection (IP):

IP40

Warranty:

2 year


DTT-3	96 × 96 mm	×4	0-300 V AC	0-500 V AC	0-9500 A AC	40-99,9 Hz	± 1 %	92 mm	515 g

This microcontroller based device was designed to measure the true effective value (TRMS) of current and voltage in all three phases and the frequency of the system. The multimeter is able to store minimum and maximum demands for both current and voltage, furthermore is capable to show these values to the user when desired. The DTT-3 type also has programmable under and over voltage limits, under and over current limits and delay time before producing contact output. The DTT-2 type is similar with DTT-3 type but without relay output. The DTT-3 type has two different contact outputs for current and voltage fault. The connection for power supply and metering is available trough pluggable terminations on the back side of device. The multimeter displays the momentary value of the current in all three phases and the frequency of the net. The line or phase voltage can be selected with front panel pushbuttons and these momentary values are readable from the display. A LED lamp marks the selected phase. The current transformer (CT) ratio is also selectable with front panel pushbuttons.